How-to install a SIM card into the BLOX

This page describe the steps necessary for installing a SIM card for the CB-0200 and CB-0210 modules

Introduction

The CB-0200 and CB-0210 communication modules have an internal LTE Cat. 4 modem. This modem needs a SIM card to register itselves to a cellular network. This how-to describes the steps to take to install the SIM card into the BLOX device.

Prerequisites

Following tools and modules are necessary for this how-to guide:

Allen key size 2.
Flat head screwdriver with max. tip width of 3mm.
Any BLOX device with at CB-0200 or CB-0210 communication module.

Step by step guide

Step 1

Loosen the 2 hex screws with the allen key.

Step 2

Open the module cover carefully and place it to the left side.
Make sure you don’t disconnect the antenna cables.

Step 3

In case you have an CB-0200 module, you can skip this step and proceed with step 4

This step need to be done carefully as it could damage the module.

The gigabit ethernet board need to be removed. This can be done with the flat head screwdriver.
Place the flat head in one of the holes as showed below and pull it gentley backwards to lift the board.
When the board is slightly lifted, place the flat head in the other hole and repeat the same.
Repeat this 2-3 times till the board will be completely lifted and the board can be removed by hand.

Move the gigabit ethernet board close to the cover as showed below.

Step 4

Place the SIM card in front of the SIM card holder as showed below.
Make sure the SIM card contacts are pointing below and not up.

Slide the SIM card gently into the holder all the way to the end as showed below.

Step 5

Place the gigabit ethernet board back and press gently on the board till the board clicks into the connector.
Afterwards, place the cover back in position. Make sure there are no cables squeezed between the cover and the BLOX enclosure.
Mount the cover again with the 2 hex screws.